The roofing
Starter strip, field shingles and ridge caps, or the panels and trim for a metal roof in straight, even courses.
Roof Replacement
Roof Installation Elmwood Park, NJ
A Elmwood Park roofing contractor can install asphalt shingle, metal and other roofs, following the material maker's instructions for nailing, flashing and ventilation, and most of what makes a roof last happens before the first shingle goes down. Dial (551) 367-0165 to talk with a local roofer about installation.
A quality roofing material can still fail early if it is installed carelessly. High nailing lets wind peel shingles off, a skipped kickout flashing sends water down into the wall and a poorly cut valley lets water work sideways under the shingles. By the time they show up, the stain is already on the ceiling.
Before anything is ordered, the roofer and homeowner settle on the roofing material. Architectural, or dimensional, asphalt shingles are the most common choice on houses, with thinner three-tab shingles still used on some homes and sheds, while standing seam or exposed fastener metal, concrete or clay tile and slate each need their own methods and fasteners. Roof pitch matters too, since standard shingles need enough slope to shed water and very low pitches call for a membrane instead.
It helps to bring a few details to the first conversation. Say whether the job is a tear-off, an addition or new construction, and whether you have a material or color picked out.
Roof Installation is often paired with roof replacement and shingle roof installation, depending on the cause.
Looking for Elmwood Park roof installation? Call (551) 367-0165 to talk to a local roofer.
Call nowThe process
Steps in a roof installation
Each layer protects the one under it, so the order is not optional.
Ready the decking
Installation starts on a sound, dry deck, so damaged sheathing is cut out and replaced first. On an overlay, the old shingles must lie flat, and any badly curled ones are cut back or replaced.
Install the ice barrier
The eaves get drip edge and a band of ice and water shield, and every valley gets a full-width strip. Codes in colder areas often require the ice barrier to reach a set distance inside the exterior wall.
Lay the underlayment
Underlayment rolls go on from the eaves up, with laps that shed water down the roof. Most crews now use synthetic underlayment, which holds up better to foot traffic and weather.
Install flashing
Flashing goes in as the roofing goes up: step pieces at walls, a kickout at the bottom edge and boots on every pipe. Sealant is a backup, not the flashing itself.
Lay the shingles
After a starter course, the crew lays shingles row by row, keeping the exposure even and the nails inside the nail strip. Valleys are finished as open metal, closed cut or woven, depending on the material and the plan.
Cap the ridge
Exhaust vents go in near the peak and the ridge is capped. Balanced intake and exhaust keep the attic drier in winter and cooler in summer.
What is included
Parts of a new roof
Drip edge
Metal edges around the whole roof finishes the edges cleanly.
Ice barrier
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck acts as the second layer of protection.
Roof vents
Ridge vents or other exhaust paired with soffit intake for a drier attic all year.
Flashing
New flashing at every wall, chimney and vent pipe instead of reusing old metal.
Related service
New Roof Installation Elmwood Park, NJ
New roof installation covers three common jobs: replacing a roof after tear-off, roofing a new home and roofing an addition. Tie-ins between new and old roofs are a common leak point, so they need full ice barrier and careful flashing. Ask the roofer how the tie-in will be handled and whether any of the existing roof will be replaced to make it work.
Manufacturers publish exact steps for their products, and local code usually requires following them. A Elmwood Park roofer should be able to explain how many nails per shingle will be used, what underlayment goes down and what ventilation the attic will have. Clear, specific answers are a good sign the details will be done right.
Related service
Roof Overlay Elmwood Park, NJ
An overlay skips the tear-off and lays new shingles over the current roof. It is only allowed on a roof with one existing layer that lies flat over a solid deck. It saves the labor of a tear-off and keeps the house closed during the job.
There are good reasons most roofers prefer a tear-off. Nobody can see or repair the decking, the old flashing tends to stay in place, the extra weight sits on the framing, and bumps in the old roof can telegraph through the new shingles. If you do go that route, make sure the scope still includes new flashing, drip edge and pipe boots.
Local help
Roof Installation Near Me
In Elmwood Park, new roofs go on everything from decades-old homes to recent builds. From Elmwood Park out to neighboring communities such as Garfield, Fair Lawn, Paterson and Lodi, roofers see plank decks and thin attic vents on older houses and complex rooflines with many valleys on newer ones, and a careful installation is what lets a new roof ride out years of weather.
Searching for roof installation near me from Elmwood Park or Garfield, Fair Lawn, Paterson and Lodi? Call (551) 367-0165 to talk to a roofer who works in your part of town.
How the weather here affects roofs around Elmwood Park
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Elmwood Park, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Elmwood Park
Local roofers see the same roofs and storm damage across Elmwood Park and nearby towns.
Know what happens next
Ask the roofer about the cause, the options and the estimate before work starts.
Roof Installation questions
What goes under a new roof?
The layers under the roofing are the drip edge, ice and water shield and a full layer of underlayment. Starter strip, step and kickout flashing and new pipe boots are also part of a proper installation.
What type of roof should I install?
The right material depends on the roof pitch, the weight the framing can carry, the style of the house and how long you plan to stay. Dimensional shingles fit most houses, metal offers a long life, and heavy tile or slate may need the structure checked first. A quick call to (551) 367-0165 is a good place to start that conversation.
How long does it take to install a new roof?
A typical house takes one to three working days once materials are on site. Larger, steeper or more cut-up roofs need more days.
Do I need a permit for roof installation?
Permit rules are set locally, and many places require one. Ask who will apply for the permit and whether an inspection is required.
What happens if a roof is installed in winter?
Winter installation is possible, with a few precautions. Crews keep shingles warm and may hand seal them, since the strips will not stick until the sun warms them. Ice and snow on the deck must be cleared before anything is installed.
More questions? Call (551) 367-0165
Related services
Roof Replacement
Full tear-off and replacement for roofs that are worn out, storm beaten or leaking in several places, built to current code from the decking out.
Learn moreShingle Roof Installation
A full shingle roof system: underlayment, ice barrier, starter, flashing, shingles and ventilation, for new homes, additions and reroofs.
Learn moreMetal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, for homes, garages and outbuildings.
Learn moreNew Construction Roofing
New construction roofs coordinated with the builder's schedule, with flashing timed around windows and siding.
Learn more
Looking for something else?
See all roofing servicesGet roof installation help in Elmwood Park
Call (551) 367-0165 to talk to a roofer serving Elmwood Park, NJ.