Starter strip
Drip edge and a sealed starter row protect the roof edges so water drips clear of the fascia.
A new shingle roof in Elmwood Park is a system of layers, and each one has to go on in the right order for the shingles to do their job, whether the roof is on a new home, an addition or a reroof. One call to (551) 367-0165 reaches a nearby roofer who installs shingle roofs.
Shingles are only the top layer of a shingle roof. The layers under the shingles include drip edge, ice and water shield, underlayment and starter strip, each with its own job. Flashing at every wall, chimney, valley and pipe, plus intake and exhaust ventilation, finishes the system.
The first decision is the shingle itself. Most new roofs use architectural shingles, which are heavier and longer lasting than the older flat 3-tab style. Impact-resistant shingles rated Class 4 under the UL 2218 test are an option where hail is common, and some insurers treat them differently, so ask yours.
Pitch matters before anything is ordered. Asphalt shingles generally need a slope of at least 2 in 12, and roofs between 2 in 12 and 4 in 12 need extra underlayment. A low porch or shed dormer may need a membrane section joined carefully to the shingles.
If the problem goes deeper than it first looked, an Elmwood Park roofer may also recommend shingle roof replacement or roof installation.
Need shingle roof installation in Elmwood Park? Call (551) 367-0165 to talk to a local roofer.
Call nowA shingle roof is built from the eaves up, layer over layer.
On a reroof or new build, the deck is inspected and fixed first, since shingles follow every dip beneath them. A wet deck is never covered.
Metal drip edge is fastened at the eaves, and a self-adhering ice barrier covers the eaves and valleys where water and ice collect. That membrane seals around nails where ice backs water up.
Underlayment covers the deck in shingled rows, and the rake edges get their drip edge after it. Synthetic underlayment is lighter, stronger and less likely to wrinkle than felt.
A starter strip with factory sealant runs along the eaves and rakes so the first course and the edges are glued down. Without it, the first course has nothing holding its lower edge.
The field is shingled with correct offsets and nailing, with step flashing, kickout flashing and pipe boots set as the courses reach them. Valleys are either open metal or closed-cut shingle valleys.
The ridge gets a continuous vent and cap shingles, and the soffits are checked for open intake. Too little intake makes a ridge vent pull air the wrong way.
Drip edge and a sealed starter row protect the roof edges so water drips clear of the fascia.
Step, counter and kickout flashing, pipe boots and a ridge vent are installed new so the details match the shingles.
Underlayment rows are lapped from the eaves up as the second line of defense.
3-tab, architectural or impact-resistant shingles are matched to the house so the look and performance both fit.
The lowest edge of the roof gets a sealed membrane where ice dams and runoff hit hardest.
Architectural shingles go on over the same deck, underlayment and starter as any shingle, with their own nailing pattern. The double thickness only holds if the nails catch both layers, so placement is checked as the roof goes on. Compatible starter and cap products finish the edges and ridge cleanly.
Most new shingle roofs in Elmwood Park are architectural, and for good reason. They resist wind, add depth to the roofline and outlast flat shingles. A sample board viewed outside, next to the siding, is the best way to choose a color.
Asphalt shingles are the go-to residential roof, and installation quality is what separates a roof that lasts from one that does not. The shingles rarely fail first; the edges, nails and flashing do. It is fair to ask which underlayment and ice barrier will go on and where.
A new asphalt roof in Elmwood Park is usually installed in one to three days once the deck is ready. Shingles seal best in warm sun, so roofs installed in cold weather are often hand sealed along the edges. The crew will watch the forecast, since wet decking cannot be covered.
Around Elmwood Park, shingle installation covers new builds, garages, additions and full reroofs. From Elmwood Park out to neighboring towns such as Garfield, Fair Lawn, Paterson and Lodi, houses built decades ago tend to need ventilation and flashing upgrades when they get a new shingle roof, and a shingle chosen for local wind and hail makes sense anywhere storms roll through. Looking for a shingle roofer near me? Ask about the full system, from drip edge to ridge.
Need shingle roof installation around Elmwood Park? Call (551) 367-0165 for an Elmwood Park roofer who serves the towns around it too.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Elmwood Park, NJ have the roof checked in the fall and again after the snow melts.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Elmwood Park know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (551) 367-0165
Replacing an aging shingle roof once repairs no longer hold, so the new roof starts on a sound, dry deck.
Learn morePutting on a new roof the way the material maker intends, whether it is asphalt shingles, metal or another material.
Learn moreFixing hot, damp or poorly vented attics with the right mix of intake and exhaust, based on what the attic actually needs.
Learn moreSeamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, from K-style aluminum to half-round and copper.
Learn moreLooking for something else?
See all roofing servicesCall now for Elmwood Park shingle roof installation and help in the towns around it.