Broken tile replacement
Damaged tiles are swapped for tiles of the same profile and color and fastened to resist wind.
A roofer in Elmwood Park can replace cracked or broken tiles, reset slipped ones, rebed loose ridge caps and fix the flashing and underlayment that actually keep water out of a tile roof. Dial (551) 367-0165 to talk through the repair with a local roofer.
Tile roof repair starts with knowing that the tiles are not the waterproof layer. The clay or concrete tiles shed most of the rain and shield what is underneath from sun, but the underlayment on the deck below is what stops the water that gets past them.
Most repairs fall into a short list. Broken tiles from people walking the roof or from falling branches, tiles that slid down after a fastener failed and ridge caps with crumbling mortar make up most calls.
Stepping on tile in the wrong place cracks it, and wet or mossy tile is slick, so the safer move is to look from the ground with binoculars. Tell the roofer what kind of tile is on the roof, roughly how old it is and where water shows up inside, so the visit starts with matching tile on hand.
Depending on what the roofer finds, tile roof repair in Elmwood Park, NJ can go hand in hand with tile roof replacement and tile roof inspection.
Looking for Elmwood Park tile roof repair? Call (551) 367-0165 and describe the problem to a roofer who works in Elmwood Park.
Call nowA good tile repair fixes the leak without breaking more tile on the way.
Before walking the roof, the roofer looks from a ladder, from the attic and sometimes with a drone to plan a route. Experienced roofers step only on the overlapped bottom edge of tiles, or use pads, to keep from cracking them.
Water travels on the underlayment before it gets in, so the roofer removes a few tiles around the suspect area to find torn felt, rusted flashing or a nail hole.
The roofer removes broken pieces, lifts the overlapping course and fastens a matching replacement tile in the same position. Finding a match can take some searching when a profile has been discontinued, and salvaged tile often fills the gap.
Tiles that slid out of line are pushed back into position and refastened, often with a stainless or copper clip where the old nail rusted away.
A section with failed underlayment gets a lift-and-relay, which reuses the existing tile over fresh underlayment. It is the repair that saves an older tile roof from a full replacement when only part of the underlayment has failed.
Damaged tiles are swapped for tiles of the same profile and color and fastened to resist wind.
Loose tiles get new clips or fasteners so gaps in the coverage close up.
Cracked ridge mortar is replaced and caps are reset so the top of the roof stays sealed.
Leaking sections get fresh underlayment beneath the original tile without replacing the whole roof.
Rusted valley metal and worn wall or pipe flashing are repaired or replaced so water reaches the gutters instead of the attic.
Clay tile is fired at high heat, so its color runs all the way through and the tile itself can last for generations. The weak point is impact: clay tile cracks under a careless step or a dropped limb.
For clay tile repair in Elmwood Park, matching the profile, size and color is half the work. When a profile is out of production, salvaged tile or tiles borrowed from an out-of-sight area fill in on the visible slopes.
Concrete tiles are made from sand and cement and wear differently from clay. Over the years the surface finish wears off, the color fades and the tile absorbs more water, which feeds moss and adds weight.
In Elmwood Park, concrete tile repairs tend to focus on broken tiles and on underlayment that has aged under them. If moss is part of the problem, a soft wash treatment is far easier on the tile than a pressure washer.
When a tile roof leaks, the real failure is usually in the underlayment, a valley or a flashing, with the tiles only part of the story. Look for trouble at valleys, sidewalls, skylights and pipe penetrations, along with underlayment that has dried out and torn. Leaks often show up only in wind-driven rain, when water is pushed sideways under the laps.
Tile roof leak repair in Elmwood Park starts with tracing the water back from the stain, which may sit several feet downhill of the entry point. If water is dripping inside, move belongings, catch the drip and, if it is near lights or outlets, shut off power to that area at the panel if the panel is safe to reach.
In Elmwood Park, tile roofs show up on older homes with clay tile and on newer builds topped with concrete tile. From Elmwood Park out to Garfield, Fair Lawn, Paterson and Lodi, storms that knock limbs onto roofs and years of sun on the underlayment are what send most tile roofs in for repair. Getting broken tiles replaced promptly keeps sun and water off the underlayment and stretches the life of the whole roof.
For tile roof repair in Elmwood Park, NJ or nearby towns like Garfield, Fair Lawn, Paterson and Lodi, call (551) 367-0165 to reach a roofer who covers your street.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Elmwood Park, NJ have the roof checked in the fall and again after the snow melts.
Small roof problems caught early usually stay small repairs.
Local roofers see the same roofs and storm damage across Elmwood Park and nearby towns.
Ask the roofer about the cause, the options and the estimate before work starts.
More questions? Call (551) 367-0165
Full tile roof replacement when the underlayment, fasteners or tile have reached the end of their life, done slope by slope to keep the house protected.
Learn moreAn inspection of a tile roof from the ridge to the attic, with a written report of what needs attention now and what can wait.
Learn moreFinding where water gets through the roof and sealing it at the source, before wet decking and insulation turn into rot.
Learn moreFixing the metal flashing at walls, dormers, valleys and roof edges, with new metal instead of another layer of caulk.
Learn moreLooking for something else?
See all roofing servicesCall (551) 367-0165 for a local roofer in Elmwood Park and nearby towns.