Retrofit framing
Where suitable, new metal goes over the old roof on sub-framing with fasteners driven into the structure below.
Metal Roofing
Metal Roof Replacement Elmwood Park, NJ
When an old metal roof in Elmwood Park leaks in too many places to chase, replacement with new panels usually makes more sense than another round of screws and sealant, and help you decide between a tear-off, a re-cover or new panels in just the bad sections. Call (551) 367-0165 to reach a local roofer.
A metal roof needs replacing when the metal itself is failing, not just the screws. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Older roofs made from thin, lightly coated steel tend to reach that point first.
Not every metal roof replacement starts with a tear-off. A full tear-off removes the old panels and trim so the purlins or deck can be inspected and repaired, then new metal goes on. In a retrofit, new panels go over the old roof on a framing system, avoiding tear-off on large or occupied buildings.
Plenty of homeowners replace an old shingle roof with metal rather than more shingles. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. It helps to know what is on the roof now, how old it is and whether it has ever been covered over.
Depending on what the roofer finds, metal roof replacement in Elmwood Park, NJ can go hand in hand with metal roof installation and metal roof repair.
Need metal roof replacement in Elmwood Park? Call (551) 367-0165 to talk to a local roofer.
Call nowThe process
The metal roof replacement process
The order of work depends on tear-off or re-cover, but the basics are the same.
Inspect the structure
The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. This decides tear-off, re-cover or partial panel replacement.
Choose the approach
The new system is selected, whether exposed fastener or standing seam, and the method of replacement is settled. Switching to standing seam usually means adding solid decking.
Remove the old roof
Old panels, trim and fasteners are removed and sorted for scrap metal recycling. Sections are opened only when they can be dried in that day.
Restore the deck
Rotten purlins are replaced, loose ones refastened and soft decking cut out and renewed. This step is skipped on a re-cover, which is why the structure is checked first.
Panel the roof
The roof is dried in, trimmed and paneled, with new boots and flashing at every penetration. Snow guards and ventilation are added where needed.
What is included
Parts of a metal reroof
Deck repair
Damaged structure is repaired for a straight, solid roof.
New panels
New panels in the chosen profile, gauge and finish replace the old roof.
Tear-off
The worn roof is stripped down to the framing and taken for recycling.
New trim
Matching flashing at every edge in the same finish as the panels.
Related service
Metal Roof Panel Replacement Elmwood Park, NJ
When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. The damaged panel is unscrewed, the laps on either side are freed and a new panel of the same profile is lapped in and fastened. Standing seam panel swaps are possible but slower, since the seams on both sides have to be opened.
For an Elmwood Park building with one or two bad panels, panel replacement is often the sensible step. Color matching is the main limit, since new paint looks brighter than weathered panels. If many panels need swapping, a full replacement may make more sense.
Related service
Metal Roof Over Shingles Elmwood Park, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
The tradeoff is that nobody sees the deck. For Elmwood Park homes, the attic check is critical, since rotted decking will not hold fasteners. Any sign of rot, or a second layer of shingles, tips the decision to tear-off.
Local help
Metal Roof Replacement Near Me
Metal roof replacement in Elmwood Park covers old barns and shops as well as homes trading shingles for metal. Older outbuildings in Elmwood Park and nearby towns like Garfield, Fair Lawn, Paterson and Lodi often have thin exposed fastener panels from decades ago, while homes are more often switching from worn shingles to metal, which is why the condition of the purlins and deck drives the plan.
For metal roof replacement in Elmwood Park, NJ or nearby towns like Garfield, Fair Lawn, Paterson and Lodi, call (551) 367-0165 to reach a roofer who covers your street.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Elmwood Park is busiest after a hard winter and before the next one.
Why call
Why act early
Drier ceilings
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across Elmwood Park and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about metal roof replacement
How do I know my metal roof is past repair?
The tipping point comes when rust or wear is spread across the roof, not just in a few spots. If panels are perforated, the coating is gone and the fasteners no longer hold, patches will not keep up. A call to (551) 367-0165 is a good way to find out where the roof stands.
Is old metal roofing recycled?
Old steel and aluminum panels are routinely taken to a scrap metal recycler. Metal can be melted down and reused, so it rarely goes to the landfill. Ask the roofer how disposal is handled before work starts.
Is it a good idea to put metal over shingles?
Local code decides whether metal can go over existing shingles. It works best when the deck is sound and the shingles lie flat. A roofer can tell you which option fits your house.
What is a metal roof retrofit?
In a retrofit, new panels go over the old roof on spacers or purlins. It is common on larger buildings where tearing off would disrupt use. An engineer or roofer confirms the framing can carry the added load.
How is a single metal roof panel replaced?
Replacing one panel is a routine job on most ribbed and corrugated roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. New panels may look brighter than the old ones at first.
More questions? Call (551) 367-0165
Related services
Metal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, for homes, garages and outbuildings.
Learn moreMetal Roof Repair
Replacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, matched to exposed fastener and standing seam roofs alike.
Learn moreRoof Replacement
Full tear-off and replacement for roofs that are worn out, storm beaten or leaking in several places, built to current code from the decking out.
Learn moreStanding Seam Metal Roof
Long-lasting standing seam roofs, from snap-lock to mechanically seamed panels, for homes, additions and low slope roofs.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof replacement in Elmwood Park, NJ?
Call now for Elmwood Park metal roof replacement and help in the towns around it.