Roof coating
The roof is recoated after repairs which slows rust on metal.
A roofer in Elmwood Park can repair a mobile home roof by resealing open seams, replacing loose fasteners, sealing vents and the AC curb and recoating the roof so it sheds water again. Call (551) 367-0165 to reach a local roofer for mobile home roof repair.
A mobile home roof has its own weak points, and most leaks start at the same few spots. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
A slow drip can do more harm in a mobile home than in a typical house. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
The framing under a mobile home roof is light, so walking it takes care. Stepping between the supports can buckle the metal or damage the ceiling, so roofers stay on the truss lines. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
Depending on what the roofer finds, mobile home roof repair in Elmwood Park, NJ can go hand in hand with roof coating and metal roof repair.
Need mobile home roof repair in Elmwood Park? Call (551) 367-0165 and describe the problem to a roofer who works in Elmwood Park.
Call nowHere is how a roofer usually approaches a mobile home roof repair.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Inside, ceiling stains help point to where water is getting in.
Missing or loose screws are replaced and panels are secured so the roof stops rumbling. Surface rust is wire brushed and primed.
Seams and laps are cleaned, primed where needed and sealed. Membrane roofs get matching patches and seam repairs instead.
Vent caps, skylights and the AC curb get fresh sealant or new flashing, and cracked vent covers are replaced. The perimeter edge where roof meets wall is sealed as well.
A reflective coating over the whole roof ties the repairs together and slows rust. The roof must be clean and dry for the coating to stick.
The roof is recoated after repairs which slows rust on metal.
Backed out fasteners are swapped so the roof stops rumbling.
Soft spots are cut out and rebuilt so the roof is solid again.
Open seams are sealed with tape or fabric and coating so water stops getting through.
Vents, skylights and the AC curb are resealed with a sealant that suits the roof.
A full mobile home roof replacement is the answer when rust, rot or a worn membrane has spread across the roof. Replacement may include new sheathing over the trusses, fresh insulation and a new roof of metal, rubber membrane or TPO. Damaged trusses are fixed first.
A mobile home roof replacement in Elmwood Park starts with the trusses, since the new roof has to stay within what they can carry. Ask whether a permit is needed, since manufactured homes can have their own rules. Done right, the new roof should end the cycle of patching.
A roof over leaves the old roof in place and builds a new one on top. Options include a framed pitched roof that adds an attic space, an insulated membrane roof over, or new metal fastened over furring strips. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
For an Elmwood Park mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. Pitched roof overs in particular may need engineering and a permit, and they should be anchored to resist wind uplift. A good roof over ends the seam and screw leaks that plague old metal roofs.
Around Elmwood Park, mobile home roofs include older metal roofs, rubber membrane roofs and newer shingle roofs on pitched manufactured homes. Owners in Elmwood Park and neighboring communities such as Garfield, Fair Lawn, Paterson and Lodi often find that a well kept coating is the difference between a dry roof and a leaking one, while older roofs that have leaked for years often need a roof over instead.
Need mobile home roof repair around Elmwood Park? Call (551) 367-0165 for an Elmwood Park roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Elmwood Park is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local roofers see the same roofs and storm damage across Elmwood Park and nearby towns.
Ask the roofer about the cause, the options and the estimate before work starts.
More questions? Call (551) 367-0165
Liquid-applied roof coatings that seal seams, reflect heat and add years to a roof, as an option before a full tear-off.
Learn moreReplacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, matched to exposed fastener and standing seam roofs alike.
Learn moreFixing open seams, punctures, shrinkage and split flashing on EPDM rubber roofs, after the real leak point is found.
Learn moreFinding where water gets through the roof and sealing it at the source, before wet decking and insulation turn into rot.
Learn moreLooking for something else?
See all roofing servicesCall now for Elmwood Park mobile home roof repair and help in the towns around it.