Old roof removal
The existing roof is stripped to the deck so the new roof starts clean.
A roofer in Elmwood Park can replace a worn flat roof by removing the old membrane and wet insulation, fixing the deck and installing a new system with proper slope, flashing and edge metal, so the new roof drains instead of ponding. One call to (551) 367-0165 reaches a nearby flat roof replacement pro.
There is a stage when a flat roof needs a fresh start rather than another patch. Seams start failing in many places, the surface cracks or blisters across the whole roof and the insulation underneath slowly soaks up water through small leaks. Wet insulation also weighs more and slowly rots wood decks.
Before anything else, the roofer decides whether to strip the roof or recover it. A recover lays new insulation or a cover board and a new membrane over the existing roof, and codes generally allow it only when there is a single existing roof and the insulation is dry. Two layers, saturated insulation or deck damage all call for a tear-off.
A new flat roof can solve problems the old one never could. Tapered insulation adds slope toward drains, crickets divert water away from walls and curbs, and extra insulation can meet current energy codes. New edge metal, coping and drains finish the system.
Many flat roof replacement calls in Elmwood Park also turn up a need for flat roof installation or flat roof repair.
Dealing with this in Elmwood Park, NJ right now? Call (551) 367-0165 to reach a nearby roofing contractor.
Call nowGetting the base right is what makes a new flat roof last.
The existing roof is checked for layers, wet areas and deck damage. That result decides between tear-off and recover.
The new membrane is chosen to suit the roof, from white TPO or PVC to black EPDM rubber or multi-ply modified bitumen. Insulation and attachment are planned along with the membrane.
The roof is stripped one area at a time so the building is never left open overnight. Debris is lowered or chuted down to a dumpster.
Rotted wood decking is replaced, and rusted metal deck is repaired, so the new roof has a solid base. Any sag that caused ponding is noted for tapered insulation.
Tapered insulation creates slope where the deck is flat, and a cover board goes on top. Proper slope is the biggest upgrade in most replacements.
Seams are welded or taped, flashing goes up walls and curbs and new edge metal and drains complete the roof. A final walk checks every seam and detail.
The existing roof is stripped to the deck so the new roof starts clean.
Insulation is upgraded with built-in slope under a protective cover board.
A new TPO, PVC, EPDM or modified bitumen membrane is installed with welded or taped seams.
New edge metal, coping and drain bowls are installed so water leaves the roof.
Core cuts and moisture readings map wet areas to set the scope correctly.
Low slope roof replacement applies to roofs with a little pitch, roughly 2 in 12 to 4 in 12, such as porch roofs, sunrooms and older additions. Many of these roofs were first covered with shingles or rolled roofing that does not suit the pitch, which is why they leak. A new roof can use modified bitumen, EPDM or TPO, or shingles with proper low slope underlayment where allowed.
Where the low slope roof meets a steeper roof or the house wall is where most leaks start. Membrane laps up under the steeper roof and wall flashing goes behind the siding. For an Elmwood Park home, getting the tie-in right prevents most future leaks.
Flat roofs being replaced in Elmwood Park are often older tar and gravel or torch-down roofs on additions, garages and flat-roof homes. Homes in Elmwood Park and nearby places including Garfield, Fair Lawn, Paterson and Lodi benefit most when replacement also fixes drainage and adds insulation, and a good roofer will walk through the options with you.
Need flat roof replacement around Elmwood Park? Call (551) 367-0165 for an Elmwood Park roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Elmwood Park, NJ have the roof checked in the fall and again after the snow melts.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local roofers see the same roofs and storm damage across Elmwood Park and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (551) 367-0165
Installing TPO, PVC, EPDM or modified bitumen roofs on additions, garages, porches and flat-roof homes, with every wall, curb and penetration flashed properly.
Learn moreFlat roof repairs matched to the membrane, whether EPDM, TPO, PVC, modified bitumen or built-up, so the roof sheds water again without a full replacement.
Learn moreHeat-welded TPO membrane for flat and low-slope roofs, built around proper drainage, flashing and edge metal.
Learn moreTorch-down, self-adhered and cold-applied modified bitumen roofing, installed, repaired and replaced.
Learn moreLooking for something else?
See all roofing servicesCall now for Elmwood Park flat roof replacement and help in the towns around it.